chamfer

英 [ˈtʃæmfə(r)]

美 [ˈtʃæmfər]

n.  斜切面; 削角

复数：chamfers　现在分词：chamfering　过去分词：chamfered　过去式：chamfered　第三人称单数：chamfers　

COCA.44768

牛津词典

noun

• 斜切面；削角
  a cut made along an edge or on a corner so that it slopes rather than being at 90˚

英英释义

noun

• two surfaces meeting at an angle different from 90 degrees
  Synonym:bevelcant

verb

• cut a furrow into a columns
  Synonym:furrowchase
• cut a bevel on
  1. bevel the surface
  Synonym:bevel

双语例句

• Single type angle drills: Use to machine chamfer for hole of glass, stones etc. Various type and specification.
  独立倒角钻头：用于玻璃孔、石材孔倒角使用。各种型号及规格。
• Based on physical simulation of edge rolling process in Trimming-Free Plate rolling method, the affection of V rolling and chamfer rolling on the plate profile is analyzed.
  基于中厚板无切边轧制法中立轧轧边变形的物理模拟，分析了平辊立轧与倒棱轧制对中厚板断面形状的影响。
• The specialized inspector inspects the bore diameter, pitch, chamfer and finish degree of bore wall.
  加工完成后由专门检验员检验孔径、孔距、倒角大小、孔壁光洁度。
• Conclusion: Amalgam post and core technique is conservative in restoring molars for its curved root canal, big root furcation and large pulp chamfer.
  结论：对于根管弯曲、叉大、室大或C型根管的磨牙，银汞桩核修复效果良好。
• Core drills. A core drill consists of the chamfer, body, neck, and shank, as shown in Fig.12.2.
  空心钻包括斜面、钻头体、钻颈和钻柄，如图12.2所示。
• Marking chamfer and taper is a routine work in Mechanical drawing.
  在机械制图中，通常需要进行大量的倒角和锥度的标注工作。
• Select those front edges and chamfer them then click apply and chamfer it again but this time with a lower value.
  选择前面的边并倒角，然后单击应用并以较低的值再次倒角。
• The effects of rolling parameters such as plate width, roll contours, chamfer and straight chamfer parameters on the contact pressure distribution were studied.
  研究结果表明，在轧制能力范围内，轧件越宽，轧辊采用凹辊型可以使辊身部的辊间压力分布更为均匀；
• Carefully remove smaller edges or burrs on the chamfer of the crankshaft flange with an oilstone if necessary.
  如有必要，请用油石仔细去除曲轴法兰倒棱上的小边或毛刺。
• The control strategy based on constant force will result in an uneven chamfer for its characteristics in nature.
  控制策略的基础上不断的部队将结果在粗糙的槽的特点大自然。